How the Brother Stampcreator Works

How to make a stamp in less than three minutes !!
	Start the Stamp Editor program on your PC or MAC. Create any image you wish using templates, clipart, importing graphics or design your own image.
	The Stampcreator Pro™ will instantly transfer the image you have prepared on your computer onto a transparent film by using the "print" function on your computer. Opening the stamp bay window will allow a final proof reading of the stamp film.
	Position a blank stamp in the stamp bay above the film positive and the Xenon lamp assembly.
	When the door to the stamp bay is closed, the Xenon flash unit is automatically activated. The surface of the stamp is made of a light sensitive rubber material specifically developed for the Brother Stampcreator Pro™. Light from the Xenon flash causes millions of micropores in the stamp surface to close. Only pores protected by the black printing on the film positive remain open allowing ink passage for imprinting.
	The stamp blank contains the ink in a small plastic pouch. When pushing downward to attach the upper case, the packet is broken to release the ink into the rubber. The stamp is then allowed to absorb the ink prior to use. This absorption period (referred to as "cure time") varies with the size and print area of your stamp.
	While waiting for the ink to absorb you can print the stamp label and attach it to the case. After this "cure time" your stamp is ready to use.